The correct treatment method when the ultrafine pulverizer is blocked

The ultrafine pulverizer adopts the air separation particle classification system, which is still the working form of the high-efficiency pulverizer. The destruction of materials and the classification of dust are installed in the same body, and they operate independently; The technical function is stable, the noise is low, the power consumption and efficiency are high, the appearance is beautiful, the application is sensitive, the scale is wide, the damage is not caused, the powder fineness can be adjusted, and the repair is simple.

The unit is composed of main engine, auxiliary engine, collecting pipeline and electric control equipment.
There is a cyclone dust collector and a filter bag dust collector in the auxiliary machine. The wind-selective centrifugal shearing, no screen and no mesh, powder particles can be adjusted arbitrarily. After the material is destroyed, it is transported to the outlet of the discharge valve by negative pressure. , to meet the product requirements, widely used in chemical, dyes, coatings, pharmaceuticals, food and other industries in different fields beyond fine damage, the destruction of materials, classification to products are carried out in the same closed system, after dust removal, no Pollution was the complete set of environmental protection ambitions at that time.

Three treatment methods when the ultrafine pulverizer is blocked:
(1) The feeding speed is too fast and the load increases, which is one of the reasons for blocking. Solution: When using the crusher, you must pay attention. During the feeding process, you should always pay attention to the large deflection angle of the ammeter pointer. If the rated current is exceeded, it indicates that the motor is overloaded. Long-term overload will burn the motor.
In this situation, the feed gate should be reduced or closed immediately, the feeding method can also be changed, and the feed amount can be controlled by adding a feeder. There are two types of feeders: manual and active. Users should choose the appropriate feeder according to the actual situation.
(2) The discharge pipe is not smooth or the material is blocked too fast, which will block the air outlet of the pulverizer; improper matching with the conveying equipment will cause the discharge pipe to be weakened or blocked after no wind.
Solution: After finding the fault, you should first clear the delivery port to change the unmatched conveying equipment, adjust the feeding amount, and make the equipment operate normally.
(3) The hammer is broken, aging, the screen mesh is closed and ragged, and the moisture content of the damaged material is too high, which will block the pulverizer.
Solution: Broken and severely aged hammers should be updated regularly to keep the crusher in good working condition.

https://www.bolymill.com/